Error : Arria 10 emif_reset_ interrupt acknowledge

[bkanal]

Hi,

I 'm getting an Emif reset interrupt acknowledge on my board that uses Arria 10 .After receving the error ,the codes does not progress. Therefore it seems to fail DDR calibration .Any ideas on the problem ? 

Board : Name 

I2C: READY 

DRAM :Warning : Caches not enable 

emif_reset interrupt acknowledge 

emif_reset interrupt acknowledge 

[aikeu]

Hi bkanal,

Is your Arria 10 a custom board? Any different from the normal development kit?

Try to run with pre-built binary from link below and check and see if there is any difference in the outcome:

https://www.rocketboards.org/foswiki/Documentation/Arria10SoCGSRD

Thanks.

Regards,

Aik Eu

[bkanal]

Thank you very much for your reply Aik Eu. I will check.

[aikeu]

Hi bkanal,

Any follow up from the previous comment?

Thanks.

Regards,

Aik Eu

[aikeu]

Hi bkanal,

May I know are you still following up with the case?

Thanks.

Regards,

Aik Eu

[bkanal]

Hi Aik Eu,

No thanks. We solved it. Thanks for your help.

[aikeu]

Hi bkanal,

Glad to heard that the issue has been resolved.

I will close the thread then.

p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.

Thanks.

Regards,

Aik Eu