Face Problem in Modelsim-altera started edition

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

Face Problem in Modelsim-altera started edition

970 Views

i am a beginner in learning modelsim. A lot of problems i faced:

Question:

1. How to set the eda tools of simulation to altera-modelsim permanently? Each time i open a new project and need to set repeatedly.

2. I use the native link method to run the simulation of a simple counter. The simulation can’t run no matter I click run, run all and run continue. Then, I click simulate.

Then an error obtained:

# ** Error: (vsim-19) Failed to access library 'C:\altera\91\modelsim_ase\win32aloem/../altera/verilog/cycloneiii' at "C:\altera\91\modelsim_ase\win32aloem/../altera/verilog/cycloneiii".

# No such file or directory. (errno = ENOENT)….

Then, I click step, the simulate start run again.

May i know how to solve it?

thanks a lot

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.