- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am interested in getting hardcopy ASIC out of MAX10 FPGA implemented design. The proof of concept is validated in MAX10 FPGA & for production the volume can be around 10K units. The processing engine that goes into the device is a low power handheld device. So, getting a hardcopy ASIC would be beneficial for low power as well as cost of manufacturing ASICs.
From the below document, I see stratix FPGA & hardcopy IV share same IP cores thus can be interchangeable. https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/po/ss-hcasics.pdf Is Hardcopy ASIC possible with MAX10 FPGAs? Regards, RiteshLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just ask to Altera but I think 10k is low volume for ASIC..
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page