How do I verify the data I send on the f2hps bridge on the Startix 10?

[ap_mercy]

In my design I’m able to do master transfers to OCM(starting at address 0x00000000) and verify that data from the HPS by using the HPS2FPGA off set at (0x80000000). If I master the same data to the FGPA2HPS directly how can I verify this data? Which location in the HPS would I have to read?

[aikeu]

Hi ap_mercy,

The OCM is on the FPGA side, sorry that I may not know understand correctly what you are trying to do.

I think is not possble to master transfer your data to the FPGA2HPS directly and verify the data....

Maybe you can share more details in a diagram in order to have a better picture.

Thanks.

Regards,

Aik Eu

[aikeu]

Hi ap_mercy,

I will close this thread if no further questions.

Thanks.

Regards,

Aik Eu

[aikeu]

Hi ap_mercy,

We do not receive any response from you to the previous question/reply/answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

Thanks.

Regards,

Aik Eu