Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
20592 Discussions

How to configure\program Stratix IV EP4SGX530KH40I3

CDAg
Beginner
1,904 Views

I cant establish JTAG communication with this part. nCONFIG always stays low indicating the part never generates\comes out of a Power On Reset which is required for configuration to be possible. Can any let me know what I can try? I have read what I believe are all the applicable ALTERA datasheets, handbooks, and app notes, for which I have my electrical interface implemented accordingly. I have VCC coming up with 50 -100us, and VCCAUX coming up after VCC reaches its final value. I dont know what the heck I may be doing wrong.

0 Kudos
3 Replies
JohnT_Intel
Employee
815 Views
Hi, Could you help to check if there is anything that is driving the nConfig pin? The reason is that this signal is input pin.
0 Kudos
CDAg
Beginner
815 Views

Hi John, thank you very much for your response. We did already try driving the nCONFIG pin but unfortunately that did not help.

0 Kudos
JohnT_Intel
Employee
815 Views
Hi, Could you help to measure using scope on nConfig and nStatus pin? I would like to understand what is the status of the device.
0 Kudos
Reply