Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

How to get 4 Mb IDT SRAM?

Altera_Forum
Honored Contributor II
‎11-11-2010 12:31 PM
988 Views

Hi all, 

 

I am trying since 3 days by working with the Altera Board Cyclone IV GX to instantiate the the IDT SRAM for 4096 Kbytes(4 Mb) with SOPC in order to get 64 bit width. 

But I always get the following 4* (1024*8) instead 4*(256*64) during the simulation. 

 

Please I would appreciate any advices...... 

 

Regards,
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.