Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21588 Discussions

How to view a configured FPGA contents?

Altera_Forum
Honored Contributor II
‎11-13-2008 09:07 AM
1,592 Views

Hi, 

 

I have a board with Cyclone II and its config. Flash mem. What I want to do now is to verify if the contents of the config data stream (original is a POF file) is the same to the POF file I have on my PC. 

 

Is there anyway to extract the FPGA contents back to a POF file so that I can do a binary comparation? 

 

I need your soon advice. 

 

TIA
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎11-13-2008 07:19 PM
597 Views

Hello 

 

You could go to Quartus Programmer, select your .POF and check the "Verify" box only. Click on Start and it will compare your file with the one from the Flash 

 

Regards 

Thiago
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎11-15-2008 01:29 AM
597 Views

Hello, 

 

I managed to do the verification thanks to your elegant solution. 

 

Thank you 

avtx30
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.