The board is a CIII EP3C120F780C7
It has two High Speed Mezz Connector (HSMC) ports which I plan to use as follows:
HSMC_A: Bitec Camera (For receiving a video signal)
HSMC_B: Bitec Quad Video Card (For displaying the image through DVI/VGA)
I need to send initialization messages to both boards using the I2C interface but am only given the option of specifying pins for one of them! Currently I have the pins for SDA/SCL set on HSMC_B for my video output. The pins for the camera on the HSMC_A side aren't in use. Further, SOPC Builder won't let me define 2x I2C masters.
It may be that I am not clear on the I2C protocol and am asking a silly question. Anyone? :confused:
