Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

In creating part footprints for the following 3 ALTERA part numbers: 5AGXFA5H4F35C5N, 5CGXFC7C6F23C6N, 5M240ZM100A5 we need more information.

RB1321
Beginner
‎06-14-2019 12:30 PM
1,508 Views

Dimensions for the substrate pad where the balls attach to the package are required. For example - substrate pad = 410um, SMD opening = 350um. Attached adds more detail. Please provide. Thanks​

Preview file
140 KB
0 Kudos

Link Copied

1 Reply
NurAiman_M_Intel
Employee
‎06-17-2019 05:38 AM
1,223 Views

Hi Rex,

 

You can find the information regarding the substrate pad in the link below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an114.pdf

 

Go for Table 3 and you should find the information as stated conditions:

 

Cyclone V: 1.00 mm (flipchip)

Arria V: 1.00mm (flipchip)

Max V: 0.50 mm MBGA 

 

Thank you.

 

Regards,

Aim

 

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.