- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to use the LTC2308 ADC on the DE10-Standard board to measure voltage by applying a 1V voltage from a power supply(If I want to connect 1V to Channel 1). How should I wire it up?
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I afraid we do not have the information available since it is a custom board which using Cyclone V FPGA. Perhaps you can try to approach Terasic to ask regarding the wire connection of the board?
Regards,
Aqid

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page