Linux driver for loading a cyclone 10 lp in passive serial mode

[jpayne]

Hello,

I am trying to program a Cyclone 10 LP using configured in passive serial mode. I have connected the Cyclone to my main system processor, which runs Linux, over a SPI port. I am looking for a Linux driver or userspace application to configure the FPGA. I have struggled to get the fpga_mgr FPGA Manager — The Linux Kernel documentation to function. It all seems overly complicated; I am not a linux expert so might just be my inexperience... 

I am reaching out to see if anyone has some recommendations.

[Farabi]

Hello,

Please refer to this link: https://www.intel.com/content/www/us/en/support/programmable/support-resources/configuration/cfg-ps.html

regards,

Farabi

[Fakhrul]

Hi jpayne,

I wish to follow up with you about this case. Have you checked the above link shared by our community member above, or do you have any updates? Otherwise, this thread will be idling and marked as inactive, thus it will be transitioned to community support because there is no update received from you in a while.

Regards,

Fakhrul