Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21580 Discussions

Lvds Rx receiver latency

kikoss
New Contributor II
852 Views

Hello 

 

I instantiated the LVDS RX IP  - with the following parameters : 

-fpga : agilex7

-datarate : 192mbps 

-serdes factor : 6 

-income frequency : 96mhz 

 

We are interested about what's the latency of the LVDS RX ip , following the parameters above ? 

I go over the "Intel Agilex 7 LVDS SERDES User Guide: F-Series and I-Series" doc , but seems no relevant information 

 

Thx 
Kikoss

 

Labels (2)
0 Kudos
1 Solution
AqidAyman_Intel
Employee
690 Views

Hello,


You can refer more information for the LVDS SERDES Intel® FPGA IP Receiver Settings:

https://www.intel.com/content/www/us/en/docs/programmable/721819/24-2/receiver-settings.html


For the Bitslip rollover value, you can specify the maximum latency for the bit slip to inject.


Regards,

Aqid


View solution in original post

0 Kudos
5 Replies
AqidAyman_Intel
Employee
714 Views

We sincerely apologize for the inconvenience caused by the delay in addressing your Forum queries. Due to an unexpected back-end issue in our system, your Forum cases, along with others, did not get through as intended. As a result, we have a backlog of cases that we are currently working through one by one.

Please be assured that we are doing everything we can to resolve this issue as quickly as possible. However, this process will take some time, and we kindly ask for your patience and understanding during this period. The cases will be attended by AE shortly.

We appreciate your patience and understanding, and we are committed to providing you with the best support possible.

Thank you for your understanding.


0 Kudos
AqidAyman_Intel
Employee
691 Views

Hello,


You can refer more information for the LVDS SERDES Intel® FPGA IP Receiver Settings:

https://www.intel.com/content/www/us/en/docs/programmable/721819/24-2/receiver-settings.html


For the Bitslip rollover value, you can specify the maximum latency for the bit slip to inject.


Regards,

Aqid


0 Kudos
AqidAyman_Intel
Employee
645 Views

Hello,


I wish to follow up. Do you need more support/help for this issue?

Or any more concern from you before I close this thread?




0 Kudos
kikoss
New Contributor II
630 Views

Hello its fine

Thank you very much !

0 Kudos
AqidAyman_Intel
Employee
605 Views

No worries! I now transition this thread to community support. If you have a new question, Please login to ‘https://supporttickets.intel.com/s/?language=en_US’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.


0 Kudos
Reply