- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I instantiated the LVDS RX IP - with the following parameters :
-fpga : agilex7
-datarate : 192mbps
-serdes factor : 6
-income frequency : 96mhz
We are interested about what's the latency of the LVDS RX ip , following the parameters above ?
I go over the "Intel Agilex 7 LVDS SERDES User Guide: F-Series and I-Series" doc , but seems no relevant information
Thx
Kikoss
- Tags:
- latency
- lvds rx ip
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You can refer more information for the LVDS SERDES Intel® FPGA IP Receiver Settings:
https://www.intel.com/content/www/us/en/docs/programmable/721819/24-2/receiver-settings.html
For the Bitslip rollover value, you can specify the maximum latency for the bit slip to inject.
Regards,
Aqid
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We sincerely apologize for the inconvenience caused by the delay in addressing your Forum queries. Due to an unexpected back-end issue in our system, your Forum cases, along with others, did not get through as intended. As a result, we have a backlog of cases that we are currently working through one by one.
Please be assured that we are doing everything we can to resolve this issue as quickly as possible. However, this process will take some time, and we kindly ask for your patience and understanding during this period. The cases will be attended by AE shortly.
We appreciate your patience and understanding, and we are committed to providing you with the best support possible.
Thank you for your understanding.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You can refer more information for the LVDS SERDES Intel® FPGA IP Receiver Settings:
https://www.intel.com/content/www/us/en/docs/programmable/721819/24-2/receiver-settings.html
For the Bitslip rollover value, you can specify the maximum latency for the bit slip to inject.
Regards,
Aqid
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I wish to follow up. Do you need more support/help for this issue?
Or any more concern from you before I close this thread?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello its fine
Thank you very much !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No worries! I now transition this thread to community support. If you have a new question, Please login to ‘https://supporttickets.intel.com/s/?language=en_US’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page