- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Greetings,
I'm using Quartus 16.1 and trying to implement remote system upgrade over I2C using a discrete implementation on a MAX 10 (10M08SAE144C8G). After viewing the training videos it is clear that there is a requirement to use dual compressed image in QSYS. When this is done and the design is compiled, the error "14740 Configuration mode on atom ...|ufm_block does not match the project setting" is produced. If I change the QSYS setting to single uncompressed image the compilation completes without error. I don't know if the design works with this setting yet but it seems inconsistent. Am I missing some setting in the Quartus project that must be set to use dual configuration? Any suggestions for resolving this issue would be much appreciated.Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Well now that I'm wiping egg off my face, I found the proper setting in Quartus under the device options button. Sorry for clogging up the forum with this simple issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Would you be willing to share your discrete RSU design?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page