Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21323 Discussions

Problem on using the ADC of StraixII

Altera_Forum
Honored Contributor II
‎04-05-2009 12:55 PM
1,003 Views

I want to input a zipzac wave from a signal generator to the "ADC in "of the board and then obtain the result, beside assigning the pin to the input, how to set the ADC clock to run the ADconverter? because in the signaltap, it always display the message "waiting clock"...don't know what to do with that.. 

 

looking forward to your reply^^
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎04-06-2009 04:36 AM
290 Views

maybe u should check your clcok source and your trigger conditions

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.