- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi there
I'm a complete newbie; and don't really know what I doing yet :( I downloaded Quartus II 13.0 (32 bit) awhile back and after experiencing problems with (Programmer) reading Jtag! I decided to try and workout where I was going wrong through watching related videos on Youtube. After watching a few videos on the 'wizard' topic? I noticed at the 'family & device' section? I was having a problem with the set-up wizard. I can only seem to select "arria ii gx" whereas the videos I watched had the more devices available. I have board here fitted with an MAX7000. I was hoping to tinker with it; and possible learn the basics. Is there a limitation on the free software I am using? As I've followed the YT video instructions. Thanks ps Quartus detects my USB Blaster/driver installed.Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes there is difference check the link. https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/po/ss_quartussevswe.pdf But quartus 13.0 web edition supports MAX700. 1.While downloading the quartus have you selected all devices? 2.Or download the devices library (.qdz) and using quartus->tools->install device (select the directory where .qdz files are there). Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Thank you for the quick reply :D Yes I am using the web version. I think: I previously didn't down load the devices (due to additional file size/loader access). I am downloading everything again (fresh set-up). Thank you for your time and help.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page