- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
I understand what if I don't define a default value for a flop, it will be '0' for a power on reset.
But if I do want to use the reset definitions for the flops, what's reset polarity is preferable - positive edge or negative edge?
What flip flop types are available in the LUTs (D-FlipFlop with set pin, reset pin, etc)?
Thank you!
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Normally it would be negative edge but it depends on the user preference.
Thanks.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page