Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20643 Discussions

S10 Device can't load image form QSPI flash

GDeXi
Beginner
424 Views

After power on, FPGA can't load image form flash, the nstatus and nConfig set 1,but CONF_DONE and INIT_DONE set 0 , here is configuration status in SDM tooldd.png

Thanks for your help!!!

0 Kudos
3 Replies
JohnT_Intel
Employee
332 Views

Hi,

 

From the error state you provided, the issue might be related to OSC_CLK_1. May I know if you are using external clock to performed configuration? Do you provide the correct clock frequency?

 

Could you performed Stratix 10 configuration debug check list shown in https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/stratix-10/ug-s10-config.pdf Chapter 7.1?

0 Kudos
GDeXi
Beginner
332 Views

Hi

Yes,I used external clock with 125Mhz, maybe I should check it. By the way,how can I get the details about States/Error Location/Error Detail parameters ?

0 Kudos
JohnT_Intel
Employee
332 Views

Hi,

Currently we are still working on providing more detail error message in the future release.

0 Kudos
Reply