Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21595 Discussions

Simulation of Microwave power divider and combiner

Altera_Forum
Honored Contributor II
‎06-23-2010 01:18 PM
1,631 Views

I am doing my training. I have got a topic i.e. simulation and analysis of microwave power divider and combiner using MATLAB. I know only E-plane tee, magic tee, H-plane Tee, directional coupler as divider and combiner. Is there any other device too. How should i go about for simulation and analysis. Please help..!!!

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-23-2010 02:21 PM
804 Views

This is an Altera Forum for Altera products and the software tools sued for FPGA Designs. 

Not for microwave design themes. 

You better use a forum that handles software tools like Momentum, ADS, Touchstone EESof (these tools are used here in our company) 

 

I would assume that you will find someone there with the knowledge how to do that with Mathlab 

 

Regards
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.