Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21152 Discussions

State of IO in unprogrammed Max 10

AJala1
Novice
2,034 Views

I'm having trouble finding this in the documentation. What is the state of the Max 10 IO when unprogrammed? What about during programming?

0 Kudos
1 Solution
AnandRaj_S_Intel
Employee
1,179 Views

Hi,

 

  1. All I/Os pins are tri-stated until device into enters to User- Mode.(It depends on the ICB Values)
  2. The user I/O pins will then function as specified by your design.

Refer session 2.3 from below link.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf

 

Regards

Anand

 

View solution in original post

0 Kudos
1 Reply
AnandRaj_S_Intel
Employee
1,180 Views

Hi,

 

  1. All I/Os pins are tri-stated until device into enters to User- Mode.(It depends on the ICB Values)
  2. The user I/O pins will then function as specified by your design.

Refer session 2.3 from below link.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/max-10/ug_m10_config.pdf

 

Regards

Anand

 

0 Kudos
Reply