- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi !!
I'm doing project with GRAPHICS LCD on Cyclone III dev kit. I search in internet but i can't found any document about this GLCD. I use GLCD F-51852GNFQJ-LB-CAN. ThanksLink Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Have a look at this thread: http://www.alteraforum.com/forum/showthread.php?t=33383 --- Quote End --- This link is for Character LCD not Graphics LCD. I have done this project perfect. Have a look at http://alteraforums.com/forum/showth...highlight=glcd
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have problems when connect two LCD: Character & Graphics together. Some comon signals don't allow to connect : write enable pin, data/command select pin. How do I correct this error ?

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page