VGA interface with NIOS

[Altera_Forum]

Hello, 

 I want to use the port VGA of the stratix 2S180 in order to display images on the screen. However this board is not recognized by the SoPC bulider and there is no defined component to connect NIOS with the VGA. So i've to make one by my self. Has anybody tried to design such component interfaced with NIOS?. I don't know how can I make such design. Could you help me please?? Thank,  Mouna.

[Altera_Forum]

I had a similar design before, In my design, I design a VGA ip for the avalon, the IP contains VGA timing,fifo,and interface to the avalon, In nios2 , a DMA is constructed to transport the picture data from the ram to the VGA fifo. 

but at last , I'm not completely succeed.   best wishes xiaoque

[Altera_Forum]

Hello, 

 Do you mean that your IP is not functional? Could you please send me your designed IP to test it in my architecture. I'm pressed by time and i've to complete the design in few days. i'll be grateful to your help...  thank, Mouna.

[Altera_Forum]

It is my pleasure, 

just give me a email address.

[Altera_Forum]

OK, 

 you can send me an email on that adress: mm_forum@yahoo.fr  Mouna.

[Altera_Forum]

I have sent to you, if you succeed, please just give me some information. 

I want to know what's wrong with my design.   best whises xiaoque

[Altera_Forum]

--- Quote Start ---  I have sent to you, if you succeed, please just give me some information. I want to know what's wrong with my design.   best whises xiaoque  --- Quote End ---     Could you send it to me? These days ,I just do the design about the VGA, but I can't get throught it. So I want to get some ideas from yours. And my email is lvriqingkk@hotmail.com