- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
I am new to Nios processor and to embedded designing. I am comfortable with FPGA designing. I have configured Nios development kit containing Cyclone-EP1c20F400C7 FPGA with a nios processor. The hardware image has been successfully loaded to the FPGA. But I am not able to download the software image to the FPGA. I am using Nios SDK for downloading the software image. I have connected the board through the JTAG interface. I have also connected to the board via the serial interface on COM2. I am using the command: nios-run -r -p com2 hello_nios.srec I am only seeing "Waiting for target......................" Even upon pressing CPU reset on the board, I am not able to see any progress or change in status. Can someone please suggest what may be the issue. regards, rajeshLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page