Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs have moved to the Altera Community. Existing Intel Community members can sign in with their current credentials.
21618 Discussions

Weak Output pin signal

Altera_Forum
Honored Contributor II
‎02-27-2009 03:49 PM
1,116 Views

I'm using the EPM7064slc-10 chip. One of the pins is supposed to output a signal at 5V however, the signal I see on the oscilloscope is only about 1V. I have the probe directly attached to the pin to avoid any loses. WHat can I do about this?

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎02-27-2009 05:38 PM
478 Views

Nothing else connected to the pin? Pin configured as regular push-pull rather than open drain output? Then the device is possibly damaged.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.