Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21602 Discussions

compare EP3C80F780C8N and EP3C5E144C8N

Altera_Forum
Honored Contributor II
‎02-18-2013 10:16 AM
1,339 Views

Hi all, 

 

I am a beginner of using Altera. Currently, I am doing a project which optimizes the cost of a device by replacing EP3C80F780C8N with EP3C5E144C8N, while still using the old vhdl code. They are both Cyclone III device, but the number of pins are different. Do I need to modify any pin mapping? If yes, please show me how to do it.:) 

 

Thank you greatly for helping this amateur, 

 

Best Regards,
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎02-18-2013 01:59 PM
617 Views

As a quick check, you can assign the smaller FPGA to the project which will remove all pin assignments and compile to check if the logic fits in. If yes, decide about the new pin assignment. I presume that the number of IO pins is sufficient.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.