Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

how to boot Cyclone V GX series FPGA

Altera_Forum
Honored Contributor II
‎12-25-2013 03:00 AM
1,249 Views

HI Sir/Madam, 

I am using Cyclone V GX series FPGA for my application. I am new to FPGA based design. 

My question is how to Boot FPGA , is it Through SPI flash ot NAND flash. 

Could you please provide the details regarding this issue.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎12-26-2013 03:47 AM
564 Views

 

--- Quote Start ---  

HI Sir/Madam, 

I am using Cyclone V GX series FPGA for my application. I am new to FPGA based design. 

My question is how to Boot FPGA , is it Through SPI flash ot NAND flash. 

Could you please provide the details regarding this issue. 

--- Quote End ---  

 

 

Firstly, you can program fpga thru jtag interface directly. Secondly, you can configure your chip by using altera configuration device, such as EPCS4/16/64. 

 

But, i think you should read handbook firstly!
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.