Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21611 Discussions

nCE pin in PS configuration mode

Altera_Forum
Honored Contributor II
‎03-04-2011 02:22 PM
1,473 Views

As I understand, the nce pin disables configuration. But what will happen if it will be toggled during configuration in Passive Configuration mode? Will it temporary stop accepting stream, or will it stop a configuration process at all? 

 

In my application, I want to use the same SPI interface of CPU for reading data from serial flash, and to configure FPGA (Cyclone III). Memory has a CS, so no problem. But what about FPGA - will the nCE pin act as a Chip Select and temporary disable configuration while nCE=1? 

 

Thanks in advance for comments.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.