Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21616 Discussions

remote update with EPCS128, the start address can not exceed 0x3C0000?

Altera_Forum
Honored Contributor II
‎01-09-2012 06:05 AM
1,041 Views

Hello, Guys. 

I have a Stratix II EP2S90 design that uses an EPCS128 device in AS mode for remote system update. I have a factory image and an application image. When the factory image start address is 0x000000, and the application image start address is 0x3C0000 (or lower), it works (both of the images are compressed). But when I change the application image start address to 0x3F0000 or higher, first time the update successes, but all the subsequent update fails(it returns to factory image automatically). 

PS: 1. the compressed file size are 0x00F77B0 bytes. 

2. I know I can only utilize the first 32 sectors of the EPCS128 device  

as configuration addresses for stratix II. 

Thanks a lot in advance!
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.