Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
21611 Discussions

signal tap logic analyser problem!!! (STP)

Altera_Forum
Honored Contributor II
‎03-03-2013 08:47 AM
1,242 Views

Hi, 

 

anyone know is there any known issue in 12.1 and 12.1sp1 QII signal tap logic analyser? 

 

1) First, when i click run analysis / autorun analysis, the signal tap keep remaining in "waiting for trigger" stage even i didn't sent any trigger signal 

2) Without changing anything, i re-compile the design again. 

3) Now, i click run analysis / autorun analysis again, and the signal tap is working! 

 

I diff the the 2 fitter db file and found that there is a lot of different and i suspect maybe this different routing and placement make the stp working in 2nd compilation. 

 

This make me very embarrassing because many times i need to re-compile the design for 2 times in order to make the stp working! 

Anyone can help? 

 

Thanks, 

fpga89
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎03-04-2013 11:30 PM
480 Views

Seem like no other user experience my problem? :(

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.