- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have 4 drives that were removed from the Intel server motherboard S2600CP for troubleshooting. They were configured as a RAID array. Now I would like to reinstall them in the same system, in the same slots without loosing the data on the drives. How do I import the configuration using the CRTL-E or RAID Web Console 2. At this time in the Logical Layout Tab of RAID Web Console 2 they appear as Unconfigured Drives and each drive appears as Unconfigured Good.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ken,
Thank you so much for contacting us about this concern.
I was reviewing the information provided and I noticed you mentioned ESRT2; by any chance on the previous configuration of the server board did you use ESRT2 in order to have the RAID configuration?
On the other hand, are you using a RAID Controller?
If this is the case, I would like to let you know that there is no possibility to import a configuration from a Software RAID to a Hardware RAID.
Please let me know the outcome in order to make sure the information.
Regards,
Emeth O.
Intel Customer Support Technician
Under Contract to Intel Corporation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ken,
I am following up your case in order to make sure if there is anything else I can help you with?
If so, please do not hesitate and contact us back and we will be more than happy to assist you.
Regards,
Emeth O.
Intel Customer Support Technician
Under Contract to Intel Corporation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ken,
No worries, as I mentioned before the implementation you are trying to achieve is not possible.
If you had this RAID configuration on ESRT2; you will have the possibility to import the configuration on ESRT2 only.
If you have any other question, please let me know and I will be more than happy to help you.
Regards,
Emeth O.
Intel Customer Support Technician
Under Contract to Intel Corporation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ken,
Due to the fact that I have not seen any on this case I will proceed and close it.
Please for futher questions do not hesitate and contact us back and we will be more than happy to assist you.
Regards,
Emeth O.
Intel Customer Support Technician
Under Contract to Intel Corporation
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page