Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New Contributor I
869 Views

How do you remove plastic insert in toolless drivebay

Jump to solution

I can't believe I have to ask this, but I can't figure it out and can't find any documentation. Our new Wolfpass servers came with 8 tool less 2.5 inch drivebays, and for the life of me I cannot figure out how I am supposed to remove the plastic inserts in the drive bays so I can actually use them. There really should be a diagram on the cover because it is certainly not intuitive how you get these things out. Where there normally would be the 4 screws, there are four little pieces of metal that look like they are supposed to be pressed, but how would someone press all 4 at once? This seems really stupid and I'll probably feel stupid when I find out the answer.

Tags (1)
0 Kudos

Accepted Solutions
Highlighted
New Contributor I
1 View

Alright this is really is as dumb as I thought. Apparently you just pull the sides of the bay apart until you can remove the plastic. I thought I was going to break it by doing that.

View solution in original post

0 Kudos
1 Reply
Highlighted
New Contributor I
2 Views

Alright this is really is as dumb as I thought. Apparently you just pull the sides of the bay apart until you can remove the plastic. I thought I was going to break it by doing that.

View solution in original post

0 Kudos