- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
I am trying to migrate Windows Server 2008 from AHCI to RAID on board S5500BC, I downloaded the ERT2 driver from intel, and when i want to add a new hardware, then browse for the driver, the driver isnt detected ! i tried enabling megasr in the system registry and still windows starts with BSOD, is there a driver or a workaround to solve this issue, i dont know if i am in the right community
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The board you are looking support is end of interactive support (EOIS) but as a general recommendation, please follow a clean installation of the Operating System instead of moving from AHCI to RAID since that is not supported and will create data corruption making the system unreliable:
http://www.intel.com/content/www/us/en/support/server-products/server-boards/legacy-server-and-workstation-boards/intel-server-board-s5500bc-family/intel-server-board-s5500bc.html Intel® Server Board S5500BC
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
The board you are looking support is end of interactive support (EOIS) but as a general recommendation, please follow a clean installation of the Operating System instead of moving from AHCI to RAID since that is not supported and will create data corruption making the system unreliable:
http://www.intel.com/content/www/us/en/support/server-products/server-boards/legacy-server-and-workstation-boards/intel-server-board-s5500bc-family/intel-server-board-s5500bc.html Intel® Server Board S5500BC
![](/skins/images/7FC17B7B85029576C25F1E43CE255B51/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page