- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yesterday the SR300 I have was working fine but today when I switch (EG press Start Camera in the 3D scan example) on the camera It blue screens my PC with this message.
Page fault in none paged area (CtClsFlt.sys)
Since I last used the camera there have been no hardware or software changes on the PC.
I have tried reinstalling the drivers and checked the pagefile hard drive for errors.
Does anyone have any suggestions?
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I installed the driver "C3DG_0800_PCAPP_DRV_EN_1_00_07_0.exe" from creative.com and the problem went away.
Hopefully this might help someone.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page