Software Archive
Read-only legacy content
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17060 Discussions

Cannot run OnBoard LED Blink example on Galileo Gen 2

Rama_R_
Beginner
‎05-15-2015 02:28 PM
940 Views

Hi,

Am new to the Gen 2 and therefore follow the steps for Galilep Gen 2 in :

https://software.intel.com/en-us/iot/library/galileo-getting-started

The firmware is upgraded successfully and the arduino is also installed. The Galileo is also recognised by my Windows computer.

When I run the code in Arduino the upload goes fine but the the onboard LED does not blink. 

Can I be guided on what I miss here?

Thanks

Rama

Preview file
93 KB
Preview file
68 KB
Preview file
265 KB
0 Kudos

Link Copied

1 Reply
NagaVenkat_K_Intel
Employee
‎05-15-2015 03:22 PM
940 Views

From the screenshot I see that you selected Galileo as board. If you are using Gen 2 board you may need to select Galileo Gen 2. Please download the latest Intel Ardiuno 1.6.0 which should enable all the three options Edison, Galileo and Galileo Gen 2.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.