Software Archive
Read-only legacy content
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17060 Discussions

ftdi installation does not make USB Serial Port (COM12) appear in device manager

Philip_J_
Beginner
1,364 Views

Hi All,

I am following the getting-started-with-the-intel-edison-board-on-windows guide and passed the admin installation of ftdi drivers, but I don't see the USB Serial Port (COM12) shown in the device manager list of Ports after reboot. I only see Intel Edison Virtual Com Port (COM3).

https://software.intel.com/en-us/articles/getting-started-with-the-intel-edison-board-on-windows

I am running Windows 7. Does anyone know whether ftdi runs on Windows 7 or have any suggestions for things to check?

Thanks!

Phil

 

0 Kudos
1 Solution
Stewart_C_Intel
Employee
1,364 Views

I hate to say this, but do you have the second USB cable connected? The FTDI driver won't load until the console cable is connected, and it can take a few minutes to appear. Another thing to try is powering up the Edison using a separate 7-15V supply using the barrel connector. Some PC's won't negotiate a full 500mA.

 

View solution in original post

0 Kudos
2 Replies
Stewart_C_Intel
Employee
1,365 Views

I hate to say this, but do you have the second USB cable connected? The FTDI driver won't load until the console cable is connected, and it can take a few minutes to appear. Another thing to try is powering up the Edison using a separate 7-15V supply using the barrel connector. Some PC's won't negotiate a full 500mA.

 

0 Kudos
Philip_J_
Beginner
1,364 Views

Thanks that was it!

0 Kudos
Reply