- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can I pull up the MSEL pins with an external 10K resistor on my Stratix II FPGA?
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bee Gee
The MSEL pins are internal pulled down via ~5k Ohms. Pulling an MSEL pin high externally (to VCCPD = .3V) via 10K will present an indeterminate value of 1.1V to the MSEL pin. This could prevent the device from configuring. Hence you should pull MSEL high directly to VCCPD (3.3V) or via a zero ohm resistor.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is it possible to pull MSEL0 down, so i can switch with a DIP switch between AS or PS mode? I`m using a CycloneII.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
oeps whent wrong
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page