- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to send / receive data from the host PC (Linux) to the FPGA board (Cyclone) using a USB cable.
Both the host PC and FPGA board have USB ports.
I am currently using Quartus Prime Standard Edition 17.1.
How can I change the value that Quartus Prime sent data from the host PC (Linux) to the FPGA board?
How should I set the FPGA side to receive as input?
Can I send data from the FPGA side to the host PC via the USB cable?
system architecture
raspberry pi == usb2.0 == usb male-male cable == usb2.0 == FPGA board
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know that do you have install USB driver on Linux? If no, there is a document that can help you to install the USB driver on Linux:
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr.pdf
For more information about Programmer tool in Quartus, you can refer to the document as below;
https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-qps-programmer.pdf
This link can also help you to understand the procedure in program FPGA board:
Thanks
![](/skins/images/872293744008A34B36F8ABF94A46CC66/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page