- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I´m into designing a interface PCBA with the I225 Controller. The evaluationboard I´m using to test my produced board has a M.2 connector so I´ll design the edge of my PCB like the connector. The connector doesn´t use the CLKREQ# and PERST Signals. They are not connected at the evaluation board. Is it still possible to communicate via PCIe without these two auxiliary signals?
Best regards
Marco
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, @Marco000:
Thanks for your reply.
We suggest that your design should be reviewed by Intel. You should follow the procedure stated on the following website:
https://edc.intel.com/Tools/Design-Review/Default.aspx
Your questions related to this process should be addressed by filling out the form stated on the following website:
https://edc.intel.com/Tools/Design-Review/Feedback/
Best regards,
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, @Marco000:
Thank you for contacting Intel Embedded Community.
You should refer to the information stated in sections 1.1.3 and 1.1.5, on pages 3 and 4 of the Intel® Ethernet Controller I225 Design Considerations that should be found when you are logged into your Resource and Design Center (RDC) privileged account in the following website:
https://cdrdv2.intel.com/v1/dl/getContent/607353
The RDC Account Support form is the channel to process your account update request or report any inconveniences with the provided website. It can be found at:
https://www.intel.com/content/www/us/en/forms/support/my-intel-sign-on-support.html
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Carlos,
thanks for you quick answer. Sadly the signal CLKREQ is not mentioned in these sections. Can you help me with this signal?
Best regards
Marco
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, @Marco000:
Thanks for your reply.
You should refer to section 1.8, on page 21 of the document mentioned in our previous communication.
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Carlos,
this section 1.8 deals with the leakage protection circuit which can be used for the signal path, but not if the signal path is needed or I can just use a Pull-Up resistor at this pin.
Best regards Marco
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, @Marco000:
Thanks for your reply.
We suggest that your design should be reviewed by Intel. You should follow the procedure stated on the following website:
https://edc.intel.com/Tools/Design-Review/Default.aspx
Your questions related to this process should be addressed by filling out the form stated on the following website:
https://edc.intel.com/Tools/Design-Review/Feedback/
Best regards,
![](/skins/images/7FC17B7B85029576C25F1E43CE255B51/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page