FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

Clock Video Output is not working in Cyclone III FPGA

Altera_Forum
Honored Contributor II
1,799 Views

My Design consists of a clocked video output set to a resolution of 1024x768 @60Hz 65 MHz pixel clock. The data input is from the test pattern generator ip from the VIP block. 

When i build the qsys and complile my design and download the sof, it (Quartus) successfully dowloads the sof into the fpga. I had connected a HSMC-GPIO daughter board to observe the signals HS,VS,DE etc on the Oscilloscope, but none of the signals were observed in the scope. 

 

I doubt my design is correct, but am not able to troubleshoot it successfully yet, I have included my entire project file with qsys file and the top level, kindly let me know what I might have done wrong, it would be of great help. 

 

Thanks, Much appreciated for your replies. 

Sriram.
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
730 Views

Learn how to simulate your design.

0 Kudos
Altera_Forum
Honored Contributor II
730 Views

Check frame size you need. I see frame size generating from TPG is 1024x768, but CVO configured as 1920x1080

0 Kudos
Reply