Hello, I'm using Cyclone V GX to interface with RapidIO II.
I met a problem with using RapidIO II IP and Transceiver Reconfiguration Controller in Qsys.
When I connect its reconfig_from_xcvr and reconfig_to_xcvr signals there are 4 errors in messages:
rapidio2_0.reconfig_from_xcvr has a
export signal, but
alt_xcvr_reconfig_0.reconfig_from_xcvr does not.
rapidio2_0.reconfig_to_xcvr has a
export signal, but
alt_xcvr_reconfig_0.reconfig_to_xcvr does not.
alt_xcvr_reconfig_0.reconfig_from_xcvr has a
reconfig_from_xcvr signal, but
rapidio2_0.reconfig_from_xcvr does not.
alt_xcvr_reconfig_0.reconfig_to_xcvr has a
reconfig_to_xcvr signal, but
rapidio2_0.reconfig_to_xcvr does not.
If I add RapidIO (Gen1) IP instead RapidIO II, these errors don't appear.
Quartus II version is 13.1 Build 162.
Thanks
