FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6463 Discussions

Cyclone V GX: cant't connect Rapidio II IP and Transceiver Reconfiguration Controller

Altera_Forum
Honored Contributor II
1,586 Views

Hello, I'm using Cyclone V GX to interface with RapidIO II. 

 

I met a problem with using RapidIO II IP and Transceiver Reconfiguration Controller in Qsys.  

When I connect its reconfig_from_xcvr and reconfig_to_xcvr signals there are 4 errors in messages: 

 

rapidio2_0.reconfig_from_xcvr has a export signal, but alt_xcvr_reconfig_0.reconfig_from_xcvr does not. 

rapidio2_0.reconfig_to_xcvr has a export signal, but alt_xcvr_reconfig_0.reconfig_to_xcvr does not. 

alt_xcvr_reconfig_0.reconfig_from_xcvr has a reconfig_from_xcvr signal, but rapidio2_0.reconfig_from_xcvr does not. 

alt_xcvr_reconfig_0.reconfig_to_xcvr has a reconfig_to_xcvr signal, but rapidio2_0.reconfig_to_xcvr does not. 

 

If I add RapidIO (Gen1) IP instead RapidIO II, these errors don't appear. 

Quartus II version is 13.1 Build 162. 

 

Thanks
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
545 Views

Solution found! Just tried it at home desktop with Quartus II 15.0 and errors wasn't appeared. 

Thread may to be closed. Thanks :D
0 Kudos
Altera_Forum
Honored Contributor II
545 Views

Can you show me how to solve this problem. I meet the same problem.

0 Kudos
Reply