- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does anyone know if the DisplayPort Intel® IP supports the Stratix 10 FPGA (in specific v1.4)? The Intel website does not have the Stratix 10 listed at all but I see that there is a DisplayPort Intel® Stratix 10 FPGA IP Design Example User Guide https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-dex-s10-dp.pdf
- Tags:
- Intel® Stratix®
Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The DisplayPort Intel IP v1.4 doesn`t support the Stratix 10 FPGA refer the link below for v1.4,
https://www.intel.com/content/www/us/en/programmable/products/intellectual-property/ip/interface-protocols/m-alt-displayport-megacore.html
The support for Stratix 10 FPGA is added in DisplayPort IP v18.1 refer Table 1. from the link below,
https://www.intel.com/content/www/us/en/programmable/documentation/hco1421697808363.html#vge1525422597006
Regards,
Vikas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Vikas.
Does the DisplayPort IP v18.1 core for Stratix 10 FPGA support the faster 8.1 Gbps per lane (aka HBR3)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I think data link support for HBR3(8.10Gbps) is available for for Intel Arria10 & Cyclone 10GX devices only.
Refer Table 4. from the link below,
Regards,
Vikas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your reply. It looks like the support for HBR3 is only in Quartus Prime Pro, is that correct? Are there any plans to support it in regular Quartus Prime?

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page