FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6359 Discussions

SignalTap II with DSP Builder Nodes Don't Appear

Altera_Forum
Honored Contributor II
‎06-17-2011 03:35 PM
954 Views

Hi, 

 

In summary: I am using SignalTap II with DSP Builder (11.0) and many of the SignalTap II nodes in my design don't show up under the node list, even after compiling with SignalTap II enabled.  

 

Specifically: I am using SignalTap II with DSP Builder to analyze a (Filter/Data Synchronization) design which uses the Data Conversion HSMC. Everything was working fine when my design used only D2A_1 and A2D_1, but when I added the other ADC and DAC (D2A_2 and A2D_2) to my design, many of the SignalTap II nodes don't show up under my node list. I've tried saving the .mdl file to a new folder and recompiling, but this only made more of the nodes not appear under the node list. 

 

Any help would be greatly appreciated!  

 

Thank you, 

RUSHALE
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-22-2011 03:22 PM
250 Views

To whom it may concern, 

 

I solved this problem by framing the signaltap II nodes with input and output blocks. (Self-five) 

 

Best Regards, 

RUSHALE
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.