- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hallo,
Could the TSE in SGMII Mode be used with 100 MBit Full Duplex and/or Half Duplex? Can I force the Network Interface Card to either 100 MBit Full Duplex or Half Duplex and let the TSE core working with Auto Neg? Or do I have to change the register Settings? Has anybody experience with this Core? or any ideas? regards Maybe for getting a feeling what my case is: i have network card and a board with a Stratix IV GX on it. They both are connected via ethernet. And on my board the RJ45 connector is configured in SGMII Mode.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi,i'm also doing exercise about tse cor now, my kits is stratix iigx pcie,and i used mac with 1000 base -x/sgmii and pma(alt2gxb),and i want to use 100M mac ,i simulated with vwf, but i do not know whether it is right, and i do not know how to config the ff_tx_clk and ff_rx_clk, i see userguide,it says the ref_clk is 125M,but it does not define the quanta of ff_tx_clk about 10M/100M/1000M mac, now i'm troubling
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page