FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6356 Discussions

TSE in 100MBit Mode

Altera_Forum
Honored Contributor II
‎06-01-2010 11:07 AM
934 Views

Hallo, 

 

Could the TSE in SGMII Mode be used with 100 MBit Full Duplex and/or Half Duplex? 

 

Can I force the Network Interface Card to either 100 MBit Full Duplex or Half Duplex and let the TSE core working with Auto Neg? Or do I have to change the register Settings? 

 

Has anybody experience with this Core? or any ideas? 

 

regards 

 

Maybe for getting a feeling what my case is: 

i have network card and a board with a Stratix IV GX on it. They both are connected via ethernet. And on my board the RJ45 connector is configured in SGMII Mode.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-01-2010 01:10 PM
230 Views

hi,i'm also doing exercise about tse cor now, my kits is stratix iigx pcie,and i used mac with 1000 base -x/sgmii and pma(alt2gxb),and i want to use 100M mac ,i simulated with vwf, but i do not know whether it is right, and i do not know how to config the ff_tx_clk and ff_rx_clk, i see userguide,it says the ref_clk is 125M,but it does not define the quanta of ff_tx_clk about 10M/100M/1000M mac, now i'm troubling

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.