FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

Triple Mac Ethernet in SGMII mode for custom board

Vikas_bel
Beginner
‎01-24-2022 09:48 AM
318 Views

Good Evening All

 

I am using the triple mac ethernet in SGMII mode.  Auto negotiation works fine but after 19 bytes excluding pre-amble and SFD , the ip core enters in invalid frame length error . As soon as the next ethernet packet is received, same thing repeats . What can be the issue . I am using UDP for sending data .I tried with different lengths as well. I am attaching the signal tap snapshot file as well . Bottom signal is ff_rx_data(8 bit fifo is used)once it receives the 08 00,4500 , it enters invalid  frame length error. signal tap attached as wellSignal tap imageSignal tap image 

 

Regards

Vikas Kumar

Deputy Manager

RFMW,PDIC

Bharat Electronics Limited

Bangalore

stp.zip
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.