- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
when I simulated the Triple speed ethernet MAC,I added a data interface contro module to the mac,I found the signal ff_rx_data[7:0] have data stream out,but there are serval "00" bytes in the stream and the signal ff_rx_dsav was deasserted and rx_err[5:0]=6'b000110,how does that happen? I set the mac interface register as following: register offsetregister namevalue x04 scratch0 xAAAAAAAA 0x08 command_config 0x0080_00330 0x0C mac_00 x17231C0 0 0x10 mac_10x 0000CB4A 0x14 frame_length 0x5ee 0x18 pause_quant 0x0f 0x1C RX_section_empty 0x10 0x20 RX_section_full 0x10 0x24 TX_section_empty 0x10 0x28 TX_section_full 0x10 0x2C RX_almost_empty 0x08 0x30 RX_almost_full 0x08 0x34 TX_almost_empty 0x08 0x38 TX_almost_full 0x0A ox3c 0x00 0x5c 0x0c 0xe8 0x00 0xec 0x00Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have resolved that problem, set 0x20 RX_section_full 0x10 to 0x20 RX_section_full 0x00 but the signal "ff_rx_dsav" was deasserted!
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page