- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello,
I try to cascad an IFFT(v2.2.1) with an FFT(v2.2.1) in a OFDM design for channel estimation. I have simulated the entire chain with MODELSIM and all data given by the FFT is the same such as my SCILAB simulation chain. But when I integrate my design on FPGA (here STRATIX S80), the data obtained by the FFT output (observe with SignalTap) are not the same such as simulated, the design lost 8 samples. I have verify the signal for FFT CTRL, but i don't find where is the problem? if someone can help me! thanksLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
What do you mean by the design lost 8 samples ? You entered a sequence of N samples and on the ouput you have a sequence of N-8 samples ? Jérôme
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page