Hello! I am using TSE(triple speed ethernet) ip core to implement communication bewteen my pc and the FPGA board(cyclone IV). But I don't know how to configure the TSE register with verilog. I do read some information from the user guide. For example, here are from the user guide:Base registers to configure the MAC function. At the minimum, you must configure the following functions: • Primary MAC address (mac_0/mac_1) • Enable transmit and receive paths (TX_ENA and RX_ENA bits in the command_config register) But I don't know how to realize this configuration in my quartus II project with verilog. Anything can be help! Best wishes!
Hi,Register & Go through the “Implementing the Triple-Speed Ethernet MegaCore Function” training material for the detail stepwise solution, https://www.altera.com/support/training/course/otse1116p2.html Also, refer the design example & Intel FPGA Triple-Speed Ethernet IP Core User Guide & try at your end. https://www.altera.com/support/support-resources/design-examples/intellectual-property/embedded/nios... https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/ug/ug_ethernet.pdf Let me know if this has helped resolve the issue you are facing or if you need any further assistance. Best Regards Vikas Jathar Intel Customer Support – Engineering (Under Contract to Intel)