Agilex Ftile tx_serial_data is stuck at 1 during reset sequence

[MesbahKarim]

Hi,

Please the attached f_tile phy configuations and waveform. The waveform shows during reset tx_serail_data is stuck at high for both differential output.

Please let me know, if any configuration or any other issue. I am using Quartus 22.4.0.94. I am stuck at this point. Please provide a solution

Thanks

Mesbah Karim

[ZiYing_Intel]

Hi Mesbash Karim,

May I know you use which OPN number? I am now try generate the ed and debug the issue from my side.

Best regards,

Zi Ying

[ZiYing_Intel]

Hi,

Since long time no hear any feedback from you, I am now close the case.

If you have any question after the case closed, please do feel free to submit another issue.

Best regards,

Zi Ying